The solution expert in full color LED display

  1. Tel :400-6600-996
主页 > News > Industry News >

the stand or fall of full-color LED display, how to identify

2016-03-01 Industry News
Today to talk to the engineers to chat, the stand or fall of full-color LED display, how to identify, in this the learned knowledge to share with everybody:
 
The stand or fall of a full color LED display to sign can mainly from the following several aspects:
 
1, flatness, display screen surface roughness to within + / - 1 mm, to ensure that the image is not distorted, local convex or concave leads to display the visual Angle of corner. The stand or fall of flatness is mainly decided by the production process.
 
2, brightness and the viewing Angle: indoor full color brightness to above 800 CD/m2, outdoor full color brightness to above 1500 CD/m2, to guarantee the normal work of the screen, otherwise it will because the brightness is too low and can't see shown in the image. Mainly by the size of the brightness of LED tube core is good or bad decision. Viewing angles directly depends on the size of the display screen of the audience, and the bigger the better. The size of the viewing Angle is mainly composed of tube core encapsulated way to decide.
 
3, white balance effect: white balance effect is one of the most important indicator display. Chromatology on red, green and blue color for the proportion of 1:4. Lost. 16 will only show the pure white, if the actual rate is a little deviation will appear white balance deviation, generally pay attention to whether there is a slant blue, white slant yellow phenomenon. The stand or fall of the white balance is mainly composed of display control system to determine, tube core of color reducibility may also be affected.
 
4, color reducibility: color reducibility is refers to the display of color reducibility, the color of the display shows both to maintain highly consistent with the colour of the source, so as to ensure the image sense of reality.
 
5, Mosaic, dead center phenomenon: Mosaic refers to appear on the screen normally on or often black small four squares, both module necrosis phenomenon, the main reason for the display of connectors quality closes nevertheless. Dead point refers to appear on the screen normally on or black often a single point, how many of the dead point mainly determined by the stand or fall of pipe core.
 
6, presence of color piece: color piece is refers to the adjacent modules between relatively clear off color, color transition in module, color piece phenomenon caused mainly by the control system is poorer, grey level is not high, caused by lower scanning frequency.